otherwise the board enters “flight” mode.
ifdef::telemini[]
TeleMini
- selects “idle” mode if receives a command packet is
- received within the
+ selects “idle” mode if it receives a command packet
+ within the
first five seconds of operation.
endif::telemini[]
mode for requests sent via TeleDongle. Commands can be issued
in idle mode over either USB or the radio link
equivalently.
- ifdef::telemini[TeleMini only have the radio link.]
+ ifdef::telemini[TeleMini only has the radio link.]
endif::radio[]
Idle mode is useful for configuring the altimeter, for
extracting data from the on-board storage chip after
endif::telemetrum,telemega,easymega[]
ifdef::telemini[]
- TeleMini are configured solely via the radio link. Of course, that
+ TeleMini is configured solely via the radio link. Of course, that
means you need to know the TeleMini radio configuration values
or you won't be able to communicate with it. For situations
when you don't have the radio configuration values,
Any operation which can be performed with a flight computer can
either be done with the device directly connected to the
computer via the USB cable, or through the radio
- link. TeleMini don't provide a USB connector and so it is
+ link. TeleMini doesn't provide a USB connector and so it is
always communicated with over radio. Select the appropriate
TeleDongle device when the list of devices is presented and
AltosUI will interact with an altimeter over the radio link.
ifdef::gps+radio[]
:aprsdevices: TeleMetrum v2.0 and TeleMega
:configure_section: _configure_altimeter
- include::aprs-operation.raw[]
+ include::aprs-operation.adoc[]
endif::gps+radio[]
=== Configurable Parameters