target/arm920t: remove command 'arm920t cp15i' deprecated in v0.4.0

[fw/openocd] / doc / openocd.texi

diff --git a/doc/openocd.texi b/doc/openocd.texi
index 0c1714e49468c9246b24732b0df4a1ae90df93fe..640687da51ac3494fa1c6c37533e91acf0980bf0 100644 (file)
--- a/doc/openocd.texi
+++ b/doc/openocd.texi
@@ -9114,23 +9114,6 @@ cables (FT2232), but might be unsafe if used with targets running at very low
 speeds, like the 32kHz startup clock of an AT91RM9200.
 @end deffn
 
-@subsection ARM720T specific commands
-@cindex ARM720T
-
-These commands are available to ARM720T based CPUs,
-which are implementations of the ARMv4T architecture
-based on the ARM7TDMI-S integer core.
-They are available in addition to the ARM and ARM7/ARM9 commands.
-
-@deffn Command {arm720t cp15} opcode [value]
-@emph{DEPRECATED -- avoid using this.
-Use the @command{arm mrc} or @command{arm mcr} commands instead.}
-
-Display cp15 register returned by the ARM instruction @var{opcode};
-else if a @var{value} is provided, that value is written to that register.
-The @var{opcode} should be the value of either an MRC or MCR instruction.
-@end deffn
-
 @subsection ARM9 specific commands
 @cindex ARM9
 
@@ -9184,18 +9167,6 @@ shown in bits 38..33 of table 9-9 in the ARM920T TRM.
 (Not all registers can be written.)
 @end deffn
 
-@deffn Command {arm920t cp15i} opcode [value [address]]
-@emph{DEPRECATED -- avoid using this.
-Use the @command{arm mrc} or @command{arm mcr} commands instead.}
-
-Interpreted access using ARM instruction @var{opcode}, which should
-be the value of either an MRC or MCR instruction
-(as shown tables 9-11, 9-12, and 9-13 in the ARM920T TRM).
-If no @var{value} is provided, the result is displayed.
-Else if that value is written using the specified @var{address},
-or using zero if no other address is provided.
-@end deffn
-
 @deffn Command {arm920t read_cache} filename
 Dump the content of ICache and DCache to a file named @file{filename}.
 @end deffn