Specifies the @var{serial_string} of the adapter to use.
If this command is not specified, serial strings are not checked.
Only the following adapter drivers use the serial string from this command:
-cmsis_dap, ft232r, ftdi, kitprog, presto, vsllink, xds110.
-The following adapters have their own command to specify the serial string:
-hla, jlink, st-link.
+cmsis_dap, ft232r, ftdi, hla, jlink, kitprog, presto, st-link, vsllink, xds110.
@end deffn
@section Interface Drivers
selection via USB address is not always unambiguous. It is recommended to use
the serial number instead, if possible.
-As a configuration command, it can be used only before 'init'.
-@end deffn
-@deffn {Config Command} {jlink serial} <serial number>
-Set the serial number of the interface, in case more than one adapter is
-connected to the host. If not specified, serial numbers are not considered.
-
As a configuration command, it can be used only before 'init'.
@end deffn
@end deffn
Currently Not Supported.
@end deffn
-@deffn {Config Command} {hla_serial} serial
-Specifies the serial number of the adapter.
-@end deffn
-
@deffn {Config Command} {hla_layout} (@option{stlink}|@option{icdi}|@option{nulink})
Specifies the adapter layout to use.
@end deffn
@emph{Note:} ST-Link TCP server does not support the SWIM transport.
@end deffn
-@deffn {Config Command} {st-link serial} serial
-Specifies the serial number of the adapter.
-@end deffn
-
@deffn {Config Command} {st-link vid_pid} [vid pid]+
Pairs of vendor IDs and product IDs of the device.
@end deffn