#!/bin/sh
+# serial number of the TeleDongle being used as the flash programmer
+DONGLE=612
+
if [ -x ../ao-tools/ao-load/ao-load ]; then
AOLOAD=../ao-tools/ao-load/ao-load
elif [ -x /usr/bin/ao-load ]; then
exit 1
fi
-echo "TeleBT v0.1 Turn-On and Calibration Program"
-echo "Copyright 2011 by Bdale Garbee. Released under GPL v2"
+echo "TeleBT v1.1 Turn-On and Calibration Program"
+echo "Copyright 2013 by Bdale Garbee. Released under GPL v2"
echo
echo "Expectations:"
-echo "\tTeleBT v0.1 powered from USB"
-echo "\t\twith TeleDonle (on /dev/ttyACM0) cabled to debug header"
+echo "\tTeleBT v1.1 powered from USB"
+echo "\t\twith TeleDonlge (on /dev/ttyACM0) cabled to debug header"
echo "\t\twith coax from SMA to frequency counter"
echo
echo -n "TeleBT serial number: "
echo $RAWLOAD
-$RAWLOAD -D 100 -r ao_led_blink.ihx
+$RAWLOAD -D $DONGLE -r ao_led_blink.ihx
echo "LEDs should be blinking"
sleep 5
-$RAWLOAD -D 100 -r ao_radio_xmit.ihx
+$RAWLOAD -D $DONGLE -r ao_radio_xmit.ihx
echo -n "Generating RF carrier. Please enter measured frequency: "
read FREQ
CAL_VALUE=`nickle -e "floor(434.55 / $FREQ * 1186611 + 0.5)"`
echo "Programming flash with cal value " $CAL_VALUE
-$AOLOAD -D 100 --cal $CAL_VALUE /usr/share/altos/telebt-v0.1*.ihx $SERIAL
+$AOLOAD -D $DONGLE --cal $CAL_VALUE /usr/share/altos/telebt-v1.0*.ihx $SERIAL
echo "Serial number "$SERIAL" programmed with RF cal value "$CAL_VALUE
-echo "Unplug and replug USB, cu to the board, confirm freq and record power"
+echo $SERIAL","$CAL_VALUE >> cal_values
+echo "Unplug debug cable, power cycle, cu to the board, confirm freq and record power"