+
+$_TARGETNAME configure -event examine-end {
+ # Enable debug during low power modes (uses more power)
+ # DBGMCU_CR |= DBG_STANDBY | DBG_STOP | DBG_SLEEP
+ mmw 0xE0042004 0x00000007 0
+
+ # Stop watchdog counters during halt
+ # DBGMCU_APB1_FZ |= DBG_IWDG_STOP | DBG_WWDG_STOP
+ mmw 0xE0042008 0x00001800 0
+}
+
+$_TARGETNAME configure -event trace-config {
+ # Set TRACE_IOEN; TRACE_MODE is set to async; when using sync
+ # change this value accordingly to configure trace pins
+ # assignment
+ mmw 0xE0042004 0x00000020 0
+}
+
+$_TARGETNAME configure -event reset-init {
+ # Configure PLL to boost clock to HSI x 4 (64 MHz)
+ mww 0x40023804 0x08012008 ;# RCC_PLLCFGR 16 Mhz /8 (M) * 128 (N) /4(P)
+ mww 0x40023C00 0x00000102 ;# FLASH_ACR = PRFTBE | 2(Latency)
+ mmw 0x40023800 0x01000000 0 ;# RCC_CR |= PLLON
+ sleep 10 ;# Wait for PLL to lock
+ mmw 0x40023808 0x00001000 0 ;# RCC_CFGR |= RCC_CFGR_PPRE1_DIV2
+ mmw 0x40023808 0x00000002 0 ;# RCC_CFGR |= RCC_CFGR_SW_PLL
+
+ # Boost JTAG frequency
+ adapter_khz 8000
+}
+
+$_TARGETNAME configure -event reset-start {
+ # Reduce speed since CPU speed will slow down to 16MHz with the reset
+ adapter_khz 2000
+}