-
-.TP
-\fB\-o\fR
-Overwrite the tape, even if it's an \fBAMANDA\fR tape\&.
-
-.TP
-\fB\-b\fR\fI  blocksize\fR
-record block size (default: 32k)
-
-.TP
-\fB\-e\fR\fI  estsize\fR
-estimated tape size (default: 1g == 1024m)
-
-.TP
-\fB\-f\fR\fI  tapedev\fR
-tape device name (default: $TAPE) The device to perform the test\&.
-
-.TP
-\fB\-t\fR\fI  typename\fR
-tapetype name (default: unknown\-tapetype)
-
+.RE
+.PP
+\fB\-f\fR
+.RS 4
+Run amtapetype even if the loaded volume is already labeled\&.
+.RE
+.PP
+\fB\-p\fR
+.RS 4
+Run only the device property discovery\&.
+.RE
+.PP
+\fB\-b\fR\fI blocksize\fR
+.RS 4
+block size to use with the device (default: 32k)
+.RE
+.PP
+\fB\-t\fR \fItypename\fR
+.RS 4
+Name to give to the new tapetype definition\&.
+.RE
+.PP
+\fB\-l\fR\fI label\fR
+.RS 4
+Label to write on the tape (default is randomly generated)\&.
+.RE
+.PP
+\fB\-o \fR\fB\fIconfigoption\fR\fR
+.RS 4
+See the "CONFIGURATION OVERRIDE" section in
+\fBamanda\fR(8)\&.
+.RE
+.PP
+If a configuration is specified, it is loaded and used to configure the device\&. Note that global configuration parameters are not applied to the device, so if you need to apply properties to a device to run amtapetype, you should supply those properties in a named
+\fIdevice\fR
+section\&.