+GDB automatically set the PC register to the correct value, 0x20000000 in this case. Then, you
+can run the program using:\\
+\begin{small}
+\begin{lstlisting}[frame=tb]
+$> continue
+\end{lstlisting}
+\end{small}
+
+\paragraph{}
+The board BLUE and GREEN leds should be blinking (those leds are near the user and reset buttons).
+
+
+\newpage
+\section{Notes}
+\paragraph{}
+By default, the disassemble command in GDB operates in ARM mode. The programs running on CORTEX-M3
+are compiled in THUMB mode. To correctly disassemble them under GDB, uses an odd address. For instance,
+if you want to disassemble the code at 0x20000000, use:\\