if [ -x ../ao-tools/ao-load/ao-load ]; then
AOLOAD=../ao-tools/ao-load/ao-load
elif [ -x /usr/bin/ao-load ]; then
if [ -x ../ao-tools/ao-load/ao-load ]; then
AOLOAD=../ao-tools/ao-load/ao-load
elif [ -x /usr/bin/ao-load ]; then
-echo "TeleBT v0.1 Turn-On and Calibration Program"
-echo "Copyright 2011 by Bdale Garbee. Released under GPL v2"
+echo "TeleBT v1.1 Turn-On and Calibration Program"
+echo "Copyright 2013 by Bdale Garbee. Released under GPL v2"
-echo "\tTeleBT v0.1 powered from USB"
-echo "\t\twith TeleDonle (on /dev/ttyACM0) cabled to debug header"
+echo "\tTeleBT v1.1 powered from USB"
+echo "\t\twith TeleDonlge (on /dev/ttyACM0) cabled to debug header"
echo -n "Generating RF carrier. Please enter measured frequency: "
read FREQ
CAL_VALUE=`nickle -e "floor(434.55 / $FREQ * 1186611 + 0.5)"`
echo "Programming flash with cal value " $CAL_VALUE
echo -n "Generating RF carrier. Please enter measured frequency: "
read FREQ
CAL_VALUE=`nickle -e "floor(434.55 / $FREQ * 1186611 + 0.5)"`
echo "Programming flash with cal value " $CAL_VALUE
echo "Unplug debug cable, power cycle, cu to the board, confirm freq and record power"
echo "Unplug debug cable, power cycle, cu to the board, confirm freq and record power"