1 # max pin width (perpendicular to axis of package) (1/100 mil)
2 # max pin length (parallel to axis of package) (1/100 mil)
3 # gap between the pads (1/100 mil)
4 # package width (1/100 mil)
5 # package height (1/100 mil)
6 # component veritcal height off board (1/100 mil)
8 # y values for drawing the pad. The Y center of the pad is 0.5*(PINL + PINS)
9 # we need a line segment of length PADL - PADW so we have end points:
10 # 0.5*(PINL + PINS) +/- 0.5*(PADL - PADW)
11 # width of soldermask relief (5 mil on each side)
12 # silkscreen width (1/100 mils)
13 # how much space to leave around the part before the
14 # silk screen (1/100 mils)
15 # lower left corner for silk screen (1/100 mil)
16 # upper right corner for silk screen (1/100 mil)
17 # how much to notch the corners by in silk to indicate polarity
18 # Element [SFlags "Desc" "Name" "Value" MX MY TX TY TDir TScale TSFlags]
19 Element[ "" "Description_nichicon_NICHICON_WT_CAP_10_10" "" "`NICHICON_WT_CAP_10_10'" 0 0 0 0 0 100 ""]
21 # Pad [rX1 rY1 rX2 rY2 Thickness Clearance Mask "Name" "Number" SFlags]
22 Pad[ 0 -20078 0 -11023 6330 1000 7330 "Plus" "1" "square"]
23 Pad[ 0 20078 0 11023 6330 1000 7330 "Minus" "2" "square"]
24 # Silk screen around package
25 # ElementLine[ x1 y1 x2 y2 width]
26 ElementLine[ 21969 21969 4465 21969 1000]
27 ElementLine[ 21969 21969 21969 -18969 1000]
28 ElementLine[ 21969 -18969 18969 -21969 1000]
29 ElementLine[ 18969 -21969 4465 -21969 1000]
30 ElementLine[ -21969 21969 -4465 21969 1000]
31 ElementLine[ -21969 21969 -21969 -18969 1000]
32 ElementLine[ -21969 -18969 -18969 -21969 1000]
33 ElementLine[ -18969 -21969 -4465 -21969 1000]