doc: Remove duplicate documentation about max flight log

This was described in detail in both the System Operation and AltosUI
chapters. Remove the duplicate from the AltosUI chapter.

Signed-off-by: Keith Packard <keithp@keithp.com>

diff --git a/doc/altusmetrum.xsl b/doc/altusmetrum.xsl
index aeb43acb4a0b8c7fdb6616e1feff9a9ec55ae009..329739e04014fde856e560aedc9e7af5a7d9256a 100644 (file)
--- a/doc/altusmetrum.xsl
+++ b/doc/altusmetrum.xsl
@@ -589,9 +589,9 @@ NAR #88757, TRA #12200
          TeleMetrum version 1.1 has 2MB of on-board flash storage,
          enough to hold over 40 minutes of data at full data rate
          (100 samples/second). TeleMetrum 1.0 has 1MB of on-board
-         storage. As data are stored at a reduced rate during
-         descent, there's plenty of space to store many flights worth
-         of data.
+         storage. As data are stored at a reduced rate during descent
+         (10 samples/second), there's plenty of space to store many
+         flights worth of data.
        </para>
        <para>
          The on-board flash is partitioned into separate flight logs,
@@ -624,6 +624,17 @@ NAR #88757, TRA #12200
          flying each time while still allowing more than sufficient
          storage for each flight.
        </para>
+       <para>
+         As TeleMini does not contain an accelerometer, it stores
+         data at 10 samples per second during ascent and one sample
+         per second during descent. Each sample is a two byte reading
+         from the barometer. These are stored in 5kB of
+         on-chip flash memory which can hold 256 seconds at the
+         ascent rate or 2560 seconds at the descent rate. Because of
+         the limited storage, TeleMini cannot hold data for more than
+         one flight, and so must be erased after each flight or it
+         will not capture data for subsequent flights.
+       </para>
       </section>
       <section>
        <title>Ignite Mode</title>
@@ -1156,31 +1167,6 @@ NAR #88757, TRA #12200
           size. A smaller value will allow more flights to be stored,
           a larger value will record data from longer flights.
        </para>
-       <para>
-         During ascent, TeleMetrum records barometer and
-         accelerometer values 100 times per second, other analog
-         information (voltages and temperature) 6 times per second
-         and GPS data once per second. During descent, the non-GPS
-         data is recorded 1/10th as often. Each barometer +
-         accelerometer record takes 8 bytes.
-       </para>
-       <para>
-         The default, 192kB, will store over 200 seconds of data at
-         the ascent rate, or over 2000 seconds of data at the descent
-         rate. That's plenty for most flights. This leaves enough
-         storage for five flights in a 1MB system, or 10 flights in a
-         2MB system.
-       </para>
-       <para>
-         The configuration block takes the last available block of
-         memory, on v1.0 boards that's just 256 bytes. However, the
-         flash part on the v1.1 boards uses 64kB for each block.
-        </para>
-       <para>
-          TeleMini has 5kB of on-board storage, which is plenty for a
-          single flight. Make sure you download and delete the data
-          before a subsequent flight or it will not log any data.
-       </para>
       </section>
       <section>
         <title>Ignite Mode</title>