add a paragraph about TeleBT battery charging to AltosDroid chapter in documentation

[fw/altos] / ao-bringup / turnon_telebt_v1

diff --git a/ao-bringup/turnon_telebt_v1 b/ao-bringup/turnon_telebt_v1
new file mode 100755 (executable)
index 0000000..f4100ae
--- /dev/null
+++ b/ao-bringup/turnon_telebt_v1
@@ -0,0 +1,62 @@
+#!/bin/sh
+
+if [ -x ../ao-tools/ao-load/ao-load ]; then
+       AOLOAD=../ao-tools/ao-load/ao-load
+elif [ -x /usr/bin/ao-load ]; then
+       AOLOAD=/usr/bin/ao-load
+else
+       echo "Can't find ao-load!  Aborting."
+       exit 1
+fi
+
+if [ -x ../ao-tools/ao-rawload/ao-rawload ]; then
+       RAWLOAD=../ao-tools/ao-rawload/ao-rawload
+elif [ -x /usr/bin/ao-rawload ]; then
+       RAWLOAD=/usr/bin/ao-rawload
+else
+       echo "Can't find ao-rawload!  Aborting."
+       exit 1
+fi
+
+echo "TeleBT v1.1 Turn-On and Calibration Program"
+echo "Copyright 2013 by Bdale Garbee.  Released under GPL v2"
+echo
+echo "Expectations:"
+echo "\tTeleBT v1.1 powered from USB"
+echo "\t\twith TeleDonlge (on /dev/ttyACM0) cabled to debug header"
+echo "\t\twith coax from SMA to frequency counter"
+echo
+echo -n "TeleBT serial number: "
+read SERIAL
+
+echo $RAWLOAD
+
+case $USER in
+    bdale)
+       DONGLE=100
+       ;;
+    keithp)
+       DONGLE=186
+       ;;
+    *)
+       echo "Unknow user"
+       exit 1
+       ;;
+esac
+
+$RAWLOAD -D $DONGLE -r ao_led_blink.ihx
+echo "LEDs should be blinking"
+sleep 5
+
+$RAWLOAD -D $DONGLE -r ao_radio_xmit.ihx
+echo -n "Generating RF carrier.  Please enter measured frequency: "
+read FREQ
+
+CAL_VALUE=`nickle -e "floor(434.55 / $FREQ * 1186611 + 0.5)"`
+
+echo "Programming flash with cal value " $CAL_VALUE
+$AOLOAD -D $DONGLE --cal $CAL_VALUE ~/altusmetrumllc/Binaries/telebt-v1.0*.ihx $SERIAL
+
+echo "Serial number "$SERIAL" programmed with RF cal value "$CAL_VALUE
+echo $SERIAL","$CAL_VALUE >> cal_values
+echo "Unplug debug cable, power cycle, cu to the board, confirm freq and record power"