This GNU Radio component implements a monostatic radar transmitter and receiver. It uses a custom FPGA build to generate a linear FM chirp waveform directly in the USRP. Echo returns are (will be) recorded to a file for offline analysis. The LFM chirp can be up to 32 MHz in width, whose center frequency is set by which transmit daughter board is installed. This gives a range resolution of approximately 5 meters. Only boards in slot A are supported. The script to run is placed in $prefix/bin: Usage: usrp_radar_mono.py [options] Options: -h, --help show this help message and exit -f FREQ, --frequency=FREQ set transmitter center frequency to FREQ in Hz, default is 0.0 -w FREQ, --chirp-width=FREQ set LFM chirp bandwidth in Hz, default is 32000000.0 -a AMPLITUDE, --amplitude=AMPLITUDE set waveform amplitude in % full scale, default is 100, --ton=TON set pulse on period in seconds, default is 5e-06, --tsw=TSW set transmitter switching period in seconds, default is 4.0625e-07, --tlook=TLOOK set receiver look time in seconds, default is 5e-06, --prf=PRF set pulse repetition frequency in Hz, default is 10000.0, -v, --verbose enable verbose output, default is disabled -D, --debug enable debugging output, default is disabled The transmitter creates an LFM chirp, evenly centered on the supplied frequency. The four timing parameters are: ton Chirp on time in seconds. tsw Transmitter switching time in seconds. This the delay after the chirp is transmitted before the receiver is enabled. These two (tsw and ton) parameters determine the minimum range of the radar. tlook The the amount of time in seconds the receiver is enabled to record echo responses ("look" time). This parameter determines the maximum radar range that can be measured, though transmitter power will also limit return strength and practical range. prf Pulse repetition frequency in Hz. This establishes to overall pulse repetition period, which results in idle time between when the receiver is turned off and the next transmitted chirp begins. Currently, only the transmitter is written. Also, there is not yet any sanity checks on the supplied parameters to the script. The receiver, when completed, will record the radar returns, preserving phase, into a file with metadata about each chirp. This is experimental code. Johnathan Corgan Corgan Enterprises LLC jcorgan@corganenterprises.com 7/18/2007